Shows how to properly install a 30 amp power cord to the terminal block connection at the back of the range.
Shows how to properly connect a flexible gas line from the gas pipe output to the gas input on the range. Also shows the ideal location of the gas pipe stub-out and cutoff/ball valve.
Covers the process for lifting the range top.
Covers the replacement of the �2 point� spark module. It shows how to replace the module by moving the range away from the wall and removing the back panel cover on a Cluny model.
Covers the replacement of the �3+1� spark module. It shows how to replace the module by moving the range away from the wall and removing the back panel cover on a Cluny model.
Shows the adjustment of the air restricting device on the burner mixing tubes. If the flame is billowing or flickering off the burner, the air/fuel ratio may need to be adjusted. Adjustment of this item may be necessary before adjustment of the �Low Flame� setting., **.
Shows the adjustment of the burners� flame height at the �Low� setting. Adjustment of the air collar may be necessary to achieve a lower setting, please view the �Air Collar Adjustment� video.
Covers the replacement of the top burner valve., **.
Covers the replacement of the gas oven valve., **.
Shows how to re-install the bottom heating element support only found in the Cluny models.
Covers the calibration process of the static & convection electric ovens. Only attempt this adjustment if the average oven temperature is proven to be greater than 25� +/- of the set dial temperature.
Covers the calibration process of the gas fired oven. Only attempt this adjustment if the average oven temperature is proven to be greater than 25� +/- of the set dial temperature.
Covers the process for converting the range between Natural Gas and Liquid Propane.
Shows how to properly install the Island Spacer.
Shows how to properly install the standard wall spacer.
Covers the LED kit installation. A slimmer design with a surrounding brass/chrome bezel, the new LED�s can be retrofitted to older ranges.
Shows how to level and raise or lower your range.
Shows how to remove and install your oven door gasket.
Shows how to re-seat your rack guides. These rack guides are often knocked out of place during transportation.
Shows how to remove and install the oven doors. The oven doors are heavy, removal of the oven doors is recommended to lighten the range if it is to be carried and/or moved.
Covers the process for resetting the electric oven reset switch., **.
Covers the re-installation of the spark plug/igniter. Spark plugs occasionally get knocked out of position or crack when impacted or stressed.
Covers the process for removing and installing the electric oven thermostat., **.
Shows how to remove and install the warming cupboard rack guides and mounting screws.
Covers the process for receiving your range, uncrating, unpacking, and moving the range for installation. -DO NOT LIFT OR MOVE THE RANGE BY THE HANDLES! Doing so will cause damage and void the warranty.-, *.
* Advise the removal of the oven doors, please view the �Oven Door Removal� video. **Also requires lifting the range top, please view the �lift the Range Top� video.
2006 - 2009 Ranges
